Description
Part #MDV010-1117
Chemiclave Part #2-50-0011-03
METERING VALVE
THIS PART IS NO LONGER AVAILABLE
Includes
- Metering Valve
- Splash Shield
- Teflon Tubing
- Service Kit *
- (4) Properly Sized High Quality O-rings
- Packet Of High Temp Lubricant
*Note: You also get Free Service Kits For The Lifetime Of The Metering Valve
Fits: Chamber
Click Here For The Step-By-Step Chemiclave Metering Valve Installation Instructions
Service Tip
When rotating the control shaft from the "Depressurized" position to the "Pressurized" position, or vise versa, a small amount of solution is forced out through the two vent holes in the outer body of the metering valve.
This is not a problem. Its suppose to do that. In fact, a Splash Shield is included with every AllClaveParts Valve and is designed to absorb the drips.
However, there are times you should be suspicious and here is what to do.
If the machine looses pressure
- Check the o-rings and tubing for cracks
- Check for excessive bubbles in the fill tube
- Then make sure that the operating temperature is below 275°F because the solution will start to boil away at 272°F. (Tip: If there are excessive bubbles in the fill tube, without a pressure leak, this means that the chamber temperature is too high
- Use the Max Register Thermometer (Part #RPT113) to confirm that the temperature is too high and not a valve problem
- If you see fluid being pushed through the vent line then check the o-rings
- If the main reservoir is depleted long before it should be, then check the o-rings
