Midmark M11 DOOR SWITCH ASSEMBLY Models M11-001 thru -019

Description

Part #MIS039-812
Midmark Part #002-0362-00

DOOR SWITCH ASSEMBLY

• See Notes below for Serial Numbers this part fits
• Includes door switch and 2 roll pins (3/32" dia. x 1/2" long)

Fits: Switch weldment

Model This Part Fits: Midmark M11 Autoclaves

Notes: This part fits Midmark M11 Autoclaves With Serial #'s -001 thru -019 with prefixes ES, ET, FP, FR, GB & NP; M11D Serial #'s -001 & -019 with prefixes GC & GD

How To Remove The Midmark M11 Autoclave Door Switch

NOTE: Units prior to serial number CZ1110/OM1000 have a different switch weldment. Since this procedure tampers with the pressure vessel integrity, it should not be attempted until a Midmark service representative has been contacted.

1. Open sterilizer door
2. Remove right hand side panel (See Instructions Here)
3. Disconnect wire harness (1) from connector (2)
4. Using 3/32 in. punch (available at any hardware store), remove two roll pins (3) from door switch bracket (4)
5. Remove door switch (5) from door switch bracket (4)

How To Install The Midmark M11 Autoclave Door Switch

1. Position door switch (5) in door switch bracket (4)
2. Using 3/32 in. punch, install two roll pins (3) in door switch bracket (4)
3. Connect wire harness (1) to connector (2)
4. Install right hand side panel (See Instructions Here)
5. Close sterilizer door