Midmark M9 DOOR SWITCH ASSEMBLY (Fits M9

Description

Part #MIS039-1211
Midmark Part #002-0362-00

DOOR SWITCH ASSEMBLY

• See Notes below for Serial Numbers this part fits
• Includes door switch and 2 roll pins (3/32" diameter x 1/2" long)

Fits: Switch Weldment


Models This Part Fits: Midmark M9 Autoclaves

Notes: Notes: This part fits M9 Serial #'s M9 -001 thru -019 with prefixes CZ, DA, DB, DX, DY, FK, FL, LA & OM; 

M9 Door Switch Removal

NOTE:
Units prior to serial number CZ1110/OM1000 have a different switch weldment. Since this procedure tampers with the pressure vessel integrity, it should not be attempted until a Midmark service representative has been contacted.

1. Open sterilizer door
2. Remove right hand side panel (See Instructions Here)
3. Disconnect wire harness (1) from connector (2)
4. Using 3/32 in. punch, remove two roll pins (3) from door switch bracket (4)
5. Remove door switch (5) from door switch bracket (4)

M9 Door Switch Installation

1. Position door switch (5) in door switch bracket (4).
2. Using 3/32 in. punch, install two roll pins (3) in door switch bracket (4)
3. Connect wire harness (1) to connector (2)
4. Install right hand side panel (See Instructions Here)
5. Close sterilizer door