Description
Part #MIV139-6039
Midmark Part #002-1361-00/014-0420-03
VENT SOLENOID VALVE
- Piston Style Valve Operator Only
- Material: Viton seat; Manifold mount; AC valve
- 120 VAC 50/60Hz. FWR; 14W
- Need Repair Kit? (Part # MIK110-4025)
- Need Coil? (Part # RCC114-4286)
- See NOTES below for Serial Number of Midmark M11 Autoclave This Part Fits
Fits: Manifold Block Assembly Newer Style Units
Note: The Spanner Nut Tool Part #ILS014-790 is required for Disassembly & Reassembly of the Midmark M11 Vent & Fill Valves
We Highly recommend using the Spanner Wrench Part #RPT501-6071 instead of the Spanner Nut alone. This tool is ideal for the tight spaces between the valves, and gives you the additional leverage you need when encountering stuck Plunger Housings. It will save you a lot of frustration & bruised knuckles
Model(s) This Part Fits: Midmark M9 & M9D Autoclaves Includes:
- Male Connector (Part # RPF228)
Also Included in: Fill/Vent Valve Assembly (Part # MIA137)
Also Available,
- Solenoid Valve (Fill) (Part # MIV138)
- Manifold Block Assembly (Part # MIA096)
- Spanner Nut(Part # ILS014)
- Double Ended Wrench(Part # RPT501)
Fits Midmark M9 Autoclaves -020 thru -022 with Serial # prefixes RN, RP, RR, & V and
Midmark M9D Autoclaves With Serial # Prefixes RW, RX & V.
Note: Midmark used a special valve on a few units that was produced by the Solenoid Solutions Company. These valves ere not "Full Wave Rectified"
The PC board does require the Fill & Vent valves to be Full Wave Rectified.
To overcome this problem, rectifiers were added between the Valve & the board as shon in the picture below:
The Midmark Solenoid Solutions valve is no longer available.
The little black boxes (aka rectifiers) have to be removed when changing valves. Throw them away.
The valve should be wired directly to the board
