OCR SOLID STATE CONTROLLER (BOARD) WITH WIRING HARNESS

Description

Part #PCT007-132
Pelton Crane Part #019110 (Board only)

SOLID STATE CONTROLLER WITH WIRING HARNESS

Includes

• Solid State Controller Part #PCT169-143
• Controller Board Wire Harness Part #PCW068-150

Note: Trim Pot (Temperature Controller) Part #PCC112-090 may have to be adjusted

Fits: Mounts on bottom plate of Autoclave

Note: Before Ordering. trace the 2 black wires leading from your thermistor (located on the chamber) to the Solid State Controller you currently have. If they are soldered ("hard wired") to your exisitng board (that is, they do not plug into the board) you will need to order the Thermistor Connector Kit Part #PCC062-088.

Installation Instructions Included

Before Testing The solid state Controller, Test each of the following components for continuity

• OCR Function Switch Part #PCS043-124
• OCR Overheat Thermostat Part #PCT042-135
• All 3 OCR Heating Elements Part #PCH023-103)

If any of these OCR components are not continuous, they must be replaced and could very well be the source of the problem you are experiencing

For a basic test of the OCR Solid State Controller, measure the voltage from the top terminal of the Power Switch To The Common Terminal Of The Function Switch

If your reading is approximately 120 volts, the board is open and will need to be replaced.
If your reading is 0 VAC, the board is probably good.

This is provided there is continuity through the function switch, over heat thermostat and the heating elements as outlined above

Model This Part Fits: Pelton Crane OCR Autoclaves