Description

Part #PCP200-419
OEM Part #1539514
Old OEM Part #0211812

DOOR INSULATION PAD

• Ceramic fiber paper (white)

Fits: Between gasket retainer and door body

Model This Part Fits: Pelton Crane Validator 8

How To Install The Validator 8 Door Insulation Pad

Follow these simple instructions to replace the pad

1. Remove the door handle by removing the 2 screws as shown in the picture above
2. As you are facing the inside of the rear open door, pull on the top bar (notice the slots for the pins to move in and out - and the hinge pins on the right that allows it to swing open
3. After swinging the assembly open, you will see a nut and washer sticking through the center of the plate as shown in the picture below
4. Remove the nut & washer, slide the disk off and remove the old insulation pad
5. Install the new Insulation Pad and follow the above instructions in reverse order to reassemble

That's it!