Statim 5000 WATER PUMP KIT (NEWER VERSION)

Description

Part #SCP051-6212
Statim Part #01-110446S Ulka Pump Statim 5000)

WATER PUMP KIT

• 120Volts, 60Hz.
• This Ulka brand pump will accommodate Statim 5000 Sterilizers with PCB Software Rev. 7 and above only
• See Notes below

Fits: Chassis
Model This Part Fits: Statim 5000 Series

Even though the software version usually indicates which water pump is installed in the Statim Autoclaves, we have run into many instances where it is not accurate.

Be sure to look at the top of the water pump currently installed in your autoclave, and compare it with the pictures below.

If you have the Newer Version with out the Over Heat Thermostat as shown in the picture above, then this is the part you need

But, if you have the Older Version with the Over Heat Thermostat as shown in the picture above, then click on the link below for the Water Pump You Need:

• Statim 5000 Water Pump (Older Version) Part #SCP050-6211

Click Here For Easy To Follow Instructions On Locating Your Software Revision Number

Notes: Includes:

• (7 pcs) Cable Tie (Part #RPT083-6210)
• Water Filter (In-Line) (Part #SCF034-3823)
• Tubing (Part #RPT373-1248)
• Metering Tube (290) (Part #SCT053)
• Spring Clip
• Mounting hardware

Also available:

• Pump Kit (Part #SCP050-6211) Invensys Pump for Sterilizers with PCB Software Rev. 6.4 or older only
• Drain Kit with Pump Filter (Part #SCK037)
• Field Service Smart Kit (Part #SCK028-523)