Description
Part #TUA066-1754
Tuttnauer Part #CT312036
DOOR SWITCH ACTIVATOR
- Use to adjust the door switch activation
- Version 3
- Includes all parts as shown
Fits: Door
Model This Part Fits: Tuttnauer 2340M Autoclaves
How To Adjust The Tuttnauer 2340M DOOR SWITCH ACTIVATOR
Here are a few tips when adjusting the Door Switch/Activator on the Tuttnauer 2340M Sterilizer
- The Heat-On light and heaters should come on when the door gasket comes
in contact and is completely sealed with the chamber surface - and not before
that. Listen for the clicking sound of the door switch at this time.
- The Door Switch/Activator (Part #TUAO66-1754) is a spring loaded activator that
can be adjusted by tightening or loosening the screw. Adjustments must be made
so that when the door is closed and the final turn of the door closing device has
been reached, two things will happen: 1) you will hear the door switch "click";
and, 2) you will see the Heat-On light go on (which means that the heaters have
been activated)
- The Door Switch Part #TUS014-1785
also can be adjusted to activate the heaters by
adjusting the positioning of the rear inside panel nut, bringing the
switch closer to or farther away from the activator. This would be necessary only
if the sterilizer does not come equipped with the spring loaded activator ver.3
- Use of the Door Switch Protector (Push Button Rubber Boot Part #TUB072-1759
for the door switch may prevent
early switch failure by protecting the switch from steam. Make the necessary
adjustments to the activator or the door switch after you have installed the boot
- Do not forget - when replacing an old door gasket with a new one, recheck the
positioning of the door switch and activator, then make any necessary adjustments,
and always check for steam leaks around the door with each of the above steps.
