Door Does Not Open After Vent Cycle
M9 & M11 Autoclaves Only
| Display/Symptom |
Cause |
What to Check |
Solution |
| Pulse Solenoid Energizes, But Door Does Not Open |
- Latch Lever Binding
- Door Lath Binding
- Tray Rack Not Pushed In All The Way Into Chamber, Causing Interference With Door
- Pressure Zero Potentiometer Out of Calibration
|
- Operate Latch Lever By Hand To Check For Resistance.
- Operate Door Latch By Chand To Check For Resistance
- Check To See If Tray Rack Is Installed Properly So That It Does Not Interfere With Door
|
- Clean / Lubricate Latch Lever
- Clean / Lubricate Door Latch
- Install Tray Rack Properly So That It Does Not Interfere With Door
- Adjust Pressure Zero Potentiometer
|
