Water Reservoir Is Full

You Must Observe The Following Conditions In Order To Determine Which Guide Will Address The Problem With your Autoclave: Water Reservoir is Low on Water, Full, or Water is Overfilling The Chamber

Error Code "C001"
(Low Water Error)
Applies to M9D & M11D Autoclaves Only


Display/Symptom Cause What to Check Solution
Cycle Will Not Run, Water Reservoir Is Full
  1. Fill Solenoid Valve Malfunctioning or is Stuck
  2. Water level Sensor Dirty or Malfunctioning
  1. Check Resistance of Fill Solenoid Valve Coil
  2. Clean Water Level Sensor & Then Perform a Continuity Test
  1. Replace Fill Solenoid Valve
  2. Replace Water Level Sensor

allclaveparts.com widget logo