E001 - DRYING CYCLE

This Troubleshooting Guide is applicable for the following Midmark Autoclave Model Numbers: M9-001 thru -019, M9D-001 thru -019, M11-001 thru -019, M11D-001 thru -019

Notice Red Led Display


If Your Midmark has a Red LED Display as shown above, then this is the right guide for you

Midmark M9 & M11 Error Code E001: DRYING CYCLE


Display/Symptom Cause What to Check Solution
E001: DRYING CYCLE E001 Appears During Drying Cycle Overheat Thermostat Activated - Caused By High Input Voltage
  1. Check facility input voltage. Voltage should not exceed Electrical Requirements
  2. Adjust the Dry Cycle Time Dip Switches (Click Here for Instructions)
  3. Check Resistance of Heating Element (Click Here and Scroll Down the Page For Instructions for M9 units, Or Click Here and Scroll Down The Page For Instructions on M11 Autoclaves. If Resistance is out of Range, Replace Heating Element
  4. Perform Continuity Check On Overheat Thermostat (Normally Closed) - Replace if Defective

allclaveparts.com widget logo