E011 - (Software Interrupt Error)

This Troubleshooting Guide is applicable for the following Midmark Autoclave Model Numbers: M9-001 thru -019, M9D-001 thru -019, M11-001 thru -019, M11D-001 thru -019

Notice Red Led Display


If Your Midmark has a Red LED Display as shown above, then this is the right guide for you

Midmark M9 & M11 Error Code E011
(Software Interrupt Error)


Display/Symptom Cause What to Check Solution
Error Code E011 (Software Interrupt Error)

Sterilizer does not complete cycle
  1. Control PC board has a Software / Hardware malfunction
  1. Disconnect power for approx. 10 seconds; then connect power & run additional cycle
  1. If error code persists, replace control PC board

allclaveparts.com widget logo