Water Fills Slowly

This Troubleshooting Guide is applicable for the following Midmark Autoclave Model Numbers: M9-001 thru -019, M9D-001 thru -019, M11-001 thru -019, M11D-001 thru -019

Notice Red Led Display


If Your Midmark has a Red LED Display as shown above, then this is the right guide for you

Chamber Fills Very Slowly


Display/Symptom Cause What to Check Solution
Takes a long time to Fill
  1. Filter / Tubing plugged
  2. Water Level Sensor Inside Chamber is Malfunctioning or Dirty
  1. Remove Filter and Tubing and Inspect
  2. Unplug Sensor from PC board & Jumper Connection on Board. Check for Proper Operation
  1. Replace / Clean Filter and/or Tubing
  2. Replace / Clean Water Level Sensor

allclaveparts.com widget logo