Midmark M7 Cover Assembly Removal / Installation

Warning: Always unplug the power cord from the wall outlet before removing any of the sterilizers cover / panels or making any repairs to prevent the possibility of electrical shock. Failure to comply with these instructions could result in severe personal injury or death.

Removing & Installing The Midmark M7 Cover Is A Straight-Forward Procedure - The Only Tool You Will Need Is a Screwdriver. Just follow these simple directions:


A. Removal
  1. Disconnect power cord from wall outlet.
  2. Loosen six screws (1, Figure 4-1), three on each side, and remove cover assembly (2) from base assembly (3).


B. Installation
  1. Align channel of cover assembly (2) with rail of base assembly (3) and then slide cover assembly onto base assembly. Secure in place by tightening six screws (1).
  2. Connect power cord to wall outlet.

allclaveparts.com widget logo