Warning: Always unplug the power cord from the wall outlet before removing any of the sterilizers cover / panels or making any repairs to prevent the possibility of electrical shock. Failure to comply with these instructions could result in severe personal injury or death.
Removing & Installing The Midmark M7 Cover Is A Straight-Forward Procedure - The Only Tool You Will Need Is a Screwdriver. Just follow these simple directions:
A. Removal - Disconnect power cord from wall outlet.
- Loosen six screws (1, Figure 4-1), three on each side, and remove cover assembly (2) from base assembly (3).
B. Installation - Align channel of cover assembly (2) with rail of base assembly (3) and then slide cover assembly onto base assembly. Secure in place by tightening six screws (1).
- Connect power cord to wall outlet.
