Troubleshooting The Tuttnauer "'POWER ON" Light

How To Find The Problem When The Power Light Does Not Come On


Cause Solution
Faulty Wall Outlet or Plug Verify power at outlet using a Volt Meter. Make sure power cord is plugged in at the wall and into the back of the machine.
Damaged Power Cord Check Power Cord For Continuity While Flexing The Cord. Replace If Defective. Click Here For Power Cord Replacements
Power Switch in Off Position, or Defective Make Sure Power is Turned on. For Instructions on Testing The Power Switch Click Here . Replace if Defective. Click Here To Find The Power Switch For Your Autoclave
Circuit Breaker (Both Facility Breaker and Autoclave Breaker Located On Back Of Autoclave) Reset breaker. Check for short circuit (see Electrical Troubleshooting Guide). If no short is found, replace Circuit Breaker
Blown Fuses Some Tuttnauer Units Will Also Have Fuses Located on the Back of The Autoclave. If Your Unit Has Them, Test Them For Continutity & Replace If Defective
Power Light is Burned Out Replace Power Light
Open Circuit Check for loose or disconnected wires. Replace Wire Harness, if necessary

allclaveparts.com widget logo