New Products
New Products
 ... more info |
Water Level is Too Low |
|
| Error Code "C001" (Low Water Error) Applies to M9D & M11D Autoclaves Only Display/Symptom Cause What to Check Solution Cycle Will Not Run ... more info | ||
|
... more info |
Open Door Light Not Coming On |
|
| OPEN THE DOOR Lamp Does Not Illuminate Applies to M9D & M11D Autoclaves Only Display/Symptom Cause What to Check Solution OPEN THE DOOR Lamp ... more info | ||
|
... more info |
Wet Instruments |
|
| Instruments Not Drying Display/Symptom Cause What to Check Solution Instruments Are Wet After Drying Cycle Is Complete Door Is Not Opening At ... more info | ||
|
... more info |
Tmperature Will Not Go Above 215 °F |
|
| Temperature Does Not Go Above 215°F (101°C) Display/Symptom Cause What to Check Solution Autoclave Will Not Complete Sterilization Cycle Slow ... more info | ||
|
... more info |
Problem With Venting |
|
| Chamber Does Not Vent Properly Display/Symptom Cause What to Check Solution Door opens after a longer than normal venting period on M9 and / or ... more info | ||
|
... more info |
Door Does Not Open After Vent Cycle |
|
| Door Does Not Open After Vent Cycle M9 & M11 Autoclaves Only Display/Symptom Cause What to Check Solution Pulse Solenoid Energizes, But Door ... more info | ||
|
... more info |
OVERFILLS |
|
| Chamber Overfills With Water Display/Symptom Cause What to Check Solution Water Pouring Out When Door is Opened Water Level Sensor Inside ... more info | ||
|
... more info |
Water Fills Slowly |
|
| Chamber Fills Very Slowly Display/Symptom Cause What to Check Solution Takes a long time to Fill Filter / Tubing plugged Water Level Sensor ... more info | ||
|
... more info |
Skips Fill Cycle |
|
| Autoclave Skips Fill Cycle Goes Directly To Heat Up Mode When Start Button Depressed Display/Symptom Cause What to Check Solution Skips Fill ... more info | ||
|
... more info |
Sterilizer Has No Power |
|
| Autoclave Has No Power Display/Symptom Cause What to Check Solution Unit displays temperature & pressure, but does not show LED status lights ... more info | ||
Categories
Important Links
- › For Missions Only
- › How To Repair Your Autoclave PC Control Board
- › OCM OCR Exploded View - UPDATED
- › Spore Test Failure
- › Sterilizer FAQ
- › Shipping Policy
- › Return/Cancellation Policy
- › Registered Trademarks
- › Disclaimer
- › Cleaning Statim Water Pump Filters
- › Payment Methods
- › International Customers
- › How To Test Autoclave Heating Elements
- › Testimonials
- › Can't Find The Door Gasket (Seal) You Need?
- › Used Autoclaves - What To Look For
Information
