Midmark M7 PILOT LIGHT (RED)

Description

Part #RCL090-858
Midmark Part #H98036

PILOT LIGHT

• 125VAC, 1/2W
• Lens: Red
• 3/16" quick disconnect tabs
• .50" Dia. mounting hole

Fits: Front Panel
Models This Part Fits: Midmark 7 &  M7 Autoclaves

A. Removal

1. Remove cover assembly (Detailed Instructions Here).
2. Disconnect two wires (1, Figure 4-5) from terminals of pilot light (2).
   
   NOTE: Pilot lights on older units do not have the four tabs. These older pilot lights are held in by friction only or by a retaining ring.
    
3. Press in on four tabs of pilot light (2) while simultaneously removing pilot light from front panel (3).

Figure 4-5. Pilot Light Removal / Installation

B. Installation

NOTE: Pilot lights on older units do not have the four tabs. These older pilot lights are held in by friction only or by a retaining ring.

1. Push pilot light (2) into front panel (3) until it pops into place.
2. Connect two wires (1) to terminals of pilot light (2).
3. Install cover assembly (Detailed Instructions Here).